Table of Contents
Advertisement
OHP 5000 User Manual
Operation (cont'd)
Settings
External Recording
1. Insert 3.5 mini plug into the jack marked AUX IN.
2. Press the REC button to begin recording.
3. Begin playback of your external source.
4. When finished, press REC button again to stop recording.
OPERATION -- Once REC button is pressed, the unit will begin
recording the content of external source audio into the unit's digital
memory. During the recording process, the audio being recorded to
memory will be heard through the speaker.
NOTE: You will not be able to record audio from the CD autoloader
with the cable plugged into the AUX IN jack.
Impedance Switch
Location -- under cover, right side of unit below SPEAKER switch
Operation -- Most telephone systems prefer an 8 ohm output. If
you are working with an older phone system, the 600 ohm setting
may be preferable.
Speaker Switch
Location -- under cover, right side of unit above IMPEDANCE switch
Operation -- turn to "ON" position to listen to program playing from
digital memory. Audio being recorded plays through speaker, regardless
of speaker switch position. Speaker switch position has no effect on
AUDIO OUT playback.
Volume Control
Location -- rear panel
Operation -- controls output level of AUDIO OUT jack. To adjust, turn
control knob clockwise to increase volume. Set proper volume level by
calling in from a phone close to the unit (or cell phone) and having your
call placed on hold.
Power Switch
Location -- rear panel
Operation -- turns power on or off. When power is on, LCD is illuminated.
5
Advertisement
Table of Contents
