Operation; Getting Started; Using The Stapler; Loading The Stapler - Grizzly H3119 Instruction Manual

OPERATION

Getting Started

Please take the time to become familiar
with this instruction manual. The informa-
tion contained will allow you to get the
maximum enjoyment and use from your
new tool.

Loading The Stapler

The Model H3119 can hold up to 85 sta-
ples in the quick loading magazine.
To load the stapler:
1. Unplug the tool from the power
source!
2. Press the silver lever while sliding back
on the staple magazine.
3. Point the tip of the stapler upward to
reveal the stapler loading area. The
loading area consists of a groove or
channel that runs along the bottom of
the stapler.
4. Load a stick of 20 gauge
staples 1 ⁄ " to 9 ⁄ " long into the loading
4 16
area.
5. Slowly slide the staple magazine back
into the closed position until the silver
lever latches in the closed position.
-4
-

Using The Stapler

DO NOT pull the trigger until the tip
of the stapler is against the surface
to be stapled. The stapler does NOT
have a safety mechanism.
1. Be sure the stapler is loaded and the
magazine is closed securely.
2. Wear safety glasses when using the
stapler
3. Plug the stapler into a 110V power
source.
4. Place the tip of the stapler against the
workpiece and pull the trigger.
Avoid repeatedly shooting staples
into the exact same location without
moving the tip of the stapler. A staple
could become jammed in the tip of
3 ⁄ " crown
16
the stapler.
H3119 Electric 3 ⁄ " Crown Stapler
16