Introduction; How To Create A New Wap Access Point - Nokia 3650 Support Manual

1.

INTRODUCTION

To obtain access to WAP services
•
You must be within the coverage of a network which supports data calls,
•
A data service must be activated on your SIM card,
•
You must have obtained a WAP access point from a WAP service provider, and
•
You must have entered the proper WAP settings.
Before you can use WAP services, you need to configure your WAP access point settings.
The exact values for the WAP access point settings are available from your WAP service
provider. Follow the instructions carefully. You can use this information to define and edit the
settings manually.
Also, your service provider may be able to send all or some of the required settings to you
via a special short message called an Over The Air (OTA) message. Once you have
received and saved the settings, you can start using the WAP application or edit the settings
as described below.
Note: To be able to use High speed data (refers to HSCSD [High Speed Circuit
Switched Data]) or GPRS (General Packet Radio Service), the network service
provider has to support these features and, if necessary, to activate them on your
SIM card. When using High speed or GPRS, extra charges may apply. Check with
your network service provider for further details and availability.
Note: The necessary settings for WAP configuration are available from your WAP
Service Provider. Depending on your service provider, you may not need to fill in
all of the settings.
2.

HOW TO CREATE A NEW WAP ACCESS POINT

1. Open the Services application
2. Press the Options button and select Settings.
3. Highlight Default access point and press the Scroll key.
You will get a pop-up "No access points defined. Define
now?" Press Yes. If there is an access point already
defined, the list of WAP access points is opened. Select the
access point you want to modify and press Options and
select Edit. If you want to create a new access point press
Options and New access point.
1/6