Charging The 3D Glasses - Epson PowerLite Home Cinema 2000 User Manual

5. Move the glasses within 10 feet (3 m) of the projector, then hold down the Pairing button on the
glasses for at least three seconds.
The status light on the glasses flashes green and red. If pairing is successful, the light turns green
for 10 seconds and then turns off.
Parent topic:

Charging the 3D Glasses

Charge the glasses when the status light on the glasses flashes red to indicate a low battery.
1. Connect the smaller end of the charging cable to the port on the bridge of the glasses.
Note: Make sure you connect the cable in the correct orientation or you may damage the glasses or
cable.
2. Connect the other end of the cable to the USB Type A port on the projector.
Note: The projector must be turned on to charge the glasses.
Viewing 3D Images
51