Rampage ACD-83 Owner's Manual page 6

32
OPEN
29
EQ
T/F
28
SEL
3, 4, 5, 6, 7
POWER/ILL BUTTON ( PWR )
Press this button to turn the unit on or off. If
the ignition switch is "on", the unit will also
turn on automatically when a compact disc is
inserted, or if any other button is pressed.
When the radio is on, each time the button
is momentarily pressed and released, the
VFD display panel back-lighting intensity
will change from low-to-medium-to-high, and
then back to low, thereby providing three dif-
ferent intensity settings.
AUDIO CONTROL (
To increase the volume level, press the
button. The volume will increase and the level
will shown on the display panel from a mini-
mum of VOL 00 to a maximum of VOL
100. To decrease the volume level, press
the button. The display will automati-
cally return to the normal indication 5 sec-
onds after the last volume adjustment or
when another function is activated. These
5 5 5 5 5
control buttons are also used in conjunction
with the Select (SEL) button
the bass, treble, balance and fader levels
as described in
16,17,33
2
ACD-83
CLAS
POP
JAZZ
LOC MONO
REG ST
LOUD
MULTI-COLOR FLOURESCENT DISPLAY
MUTE SCAN LOC
1 2
PAU SCN
23
9 28 12 22
38
/ ) SELECT
to adjust
, , and
.
19, 27, 30, 31
11, 20, 21, 36, 37
(BEHIND PANEL)
P-950W
CD-R/RW PLAYBACK
Sub. W
Tune
/Seek
/Track
AF TA EON
TP PTY
ME/CR
POWER LEVEL METER
3 4 5 6
RPT SHF D.DN D.UP MODE
24 25 26
18
39 40 35
34
15
PUSH SELECT CONTROL (SEL)
This button is used to select the audio
function (volume, bass, treble, balance, or
fade) whose setting is adjusted using the
AUDIO CONTROL buttons
SEL button once will set the unit for volume
adjustment (VOL on the display). Additional
presses will set the unit for bass adjustment
(BAS on the display panel), treble adjustment
(TRB on the display), balance (BAL), or fader
(FAD). The display will automatically return
to the normal indication 5 seconds after the
last adjustment or when another function is
activated.
NOTE: If the BAS or TRE functions are set
while the Equalizer function
active, the Equalizer function will
automatically revert to the FLAT
setting.
BASS CONTROL
To adjust the bass level, first select the Bass
mode by pressing the SEL button
BAS indication appears on the display panel.
Within 5 seconds of choosing the Bass
mode, press the AUDIO CONTROL
1
ILL
PWR
13
MONO
AS/PS
14
BAND
LOUD
8,10
. Pressing the
is
so the
128-6003A
6 of 20