Sanitaire 600 SERIES Owner's Manual page 7

Step 2
Attach Upper Cord Hook
Pull the spring on the electrical cord upward
toward the top of the handle. Make sure slots in
handle are positioned properly, see Detail A.
Insert the lower half of the spring into the upper
cord hook (B), as shown. Snap the hook into
the upper handle, directions below.
1. Place inner 2. Press hook
tab into slot around
handle
Step 3
Attach Lower Cord Hook
Insert the power cord into the lower cord hook
(C), as shown. Snap the hook into the lower
handle. Pull up on the cord to tighten but leave
enough slack near the base so the cord is not
strained when the handle is lowered. Wrap the
cord around the two cord hooks. Fasten the plug
to the cord to prevent unwinding.
Step 4
Install The Bag
Insert the bag adapter clip (E) on the bottom of
the bag collar into the bag adapter retainer (F).
Push the bag collar up and forward so the locator
lug slides into the slot indicated by the arrow.
Then turn the cam latch (G) to lock the bag onto
the rivet (H).
Loop the spring from the top of the bag onto the
bag support located to the back of the upper
cord hook (B).
3. SNAP opposite
inner tab into
place
F
E
H
G
7