Updating The Firmware - P+S Technik WEISSCAM HS-2 User Manual

2.3 Updating the Firmware

2.3.1 Updating the Debayerboard Inside the Camera
When new software releases are distributed, the internal debayerboard can be updated using a
PC or laptop and an USB cable.
1. The switched-off camera must be connected with the PC. There is a USB-B cable for doing
this. On the right camera side, plug it into INT; on the PC system, plug it into an available USB
port.
2. Open the update file "DBB.UPD.exe".
3. In the COM 2 field, specify the corresponding communication port,
e.g. COM2, COM3, etc.
To start, press the "Update firmware" button.
If there is an error message, verify that the communication port (COM) has been
entered correctly.
4. Press the "OK" button and then start the camera.
38