Operation - P+S Technik WEISSCAM HS-2 User Manual

2.2 Operation

2.2.1 Starting the Camera
Since the WEISSCAM HS-2 is shipped in various configurations, two modes must be distinguished:
the stand alone and the basic version. Both are explained separately in the sections below.
In the "standalone" version, the WEISSCAM HS-2 is controlled completely via the WEISSCAM
HandUnitHU-2. Thus, no PC system connection is necessary.
All settings of the Hand Unit HU-2 are configured via the touchscreen display and control wheel.
Important commands such as RECORD, STOP and PLAY can also be selected via hardware but-
tons.
In the "basicversion", the WEISSCAM HS-2 is controlled via a PC system. All necessary settings
are configured via the WEISSCAM Software. The software must be installed on a computer that
has an NVIDIA graphics card (minimum 8000er series).
Camera (ON/OFF switch / LEDs)
To switch on the camera, actuate the ON/OFF switch on the rear side of the camera.
If the camera is supplied with power correctly, you will instantly hear the camera's ventilation start-
ing up and the camera system will boot up. After approx. five seconds a test image is displayed
and the camera is ready.
The LEDs on the rear side indicate the status of the camera.
STATUS: Is illuminated in green: Camera is ready
–
REC: Is illuminated in blue:
–
Error: Is illuminated in red:
–
Recording
An error has occurred. Restart the camera.
2
19