Connections - P+S Technik WEISSCAM HS-2 User Manual

1.3 Connections

Sync in/out: These ports enable you to synchronise multiple WEISSCAM HS-2 cameras
with pixel accuracy. The master camera (sync generator) is initialised via
short-circuiting at the sync in and outputs the sync signal at the sync out.
Thus, multiple cameras can be connected in series and all cameras are syn-
chronised via the master camera.
ACQ EXP: You can connect devices (accessories) for controlling start/stop signals and
changes of speed here. To do so, the camera must be put into recording
mode via another operating unit (computer or WEISSCAM Hand Unit HU-2).
(will be implemented)
12V / 0.5A DC out: For supplying power to the viewfinder. Lemo 4-pin socket.
Only devices with a maximum power of 6 watts may be connected here.
12V / 3A DC out: For supplying power to auxiliary equipment. Lemo 4-pin socket.
Only devices with a maximum power of 36 watts may be connected here.
24V / 3A DC out: For supplying power to auxiliary equipment. Fischer 3-pin socket.
Only devices with a maximum power of 72 watts may be connected here.
INT: Firmware updates can be loaded onto the internal Debayerbox via this USB-B
interface. It is also possible to control the internal Debayerbox via software.
Power switch: Toggle switch for switching on the camera.
Downward: Switching on, camera boots up
Upward:
After the camera has booted up correctly, the green "STATUS" LED is illumi-
nated constantly and the camera is ready for operation.
HEX: Rotary switch for selecting the 16 presets of the internal Debayerboard
(e.g. colour temp, cine curves, focus filter etc.).
This switch directly impacts the HD-SDI output signal.
DVI-OUT: Analogue DVI signal with SVGA 800x600 pixels, for viewfinder
(see accessories) or monitor (preview).
HD-SDI Link A;B: The WEISSCAM HS-2 is equipped with an internal debayer board, which
is used to debayer the RAW data in the 1080p or 720p (RAW) signal of the
sensor in real time and convert into a YCbCr 4:2:2 single link or YCbCr
4:2:2 dual stream signal.
For resolutions outside of the HD standard (e.g. 2K with 2048x1536),
Switching off
1 1
13