Grounding; Extension Cords; Wiring - Grizzly G4186Z Instruction Manual

Grounding

In the event of an electrical short, grounding
reduces the risk of electric shock by providing
electric current a path of least resistance. This
tool is equipped with a power cord having an
equipment-grounding conductor. See Figure 1.
The outlet must be properly installed and ground-
ed in accordance with all local codes and ordi-
nances.
This equipment must be
grounded. Verify that any
existing electrical outlet
and circuit you intend to
plug
grounded. Under no cir-
cumstances should the
grounding pin from any
three-pronged
removed. Serious injury
may occur.

Extension Cords

We do not recommend the use of extension cords
on 220V equipment. It is much better to arrange
the placement of your equipment and the
installed wiring to eliminate the need for exten-
sion cords. Should it be necessary to use an
extension, make sure the cord is rated Hard
Service (Grade S) or better. Refer to the chart in
Section 1: Safety Instructions to determine the
minimum gauge for the extension cord. The
extension cord must also contain a ground wire
and plug pin. Always repair or replace extension
cords when they become worn or damaged.
-6-
into is actually
plug be
Wiring Diagram
Your Model G4186Z Bandsaw comes pre-wired
for 220 volt operation. A wiring diagram is provid-
ed at the back of this manual should it be neces-
sary to repair or revise the wiring. Always utilize a
qualified electrician when doing any electrical
work on this equipment.
We have covered some basic electrical
requirements for the safe operation of your
bandsaw. These requirements are not nec-
essarily comprehensive. You must be sure
that your particular electrical configuration
complies with local and state codes.
Ensure compliance by checking with your
local municipality or a licensed electrician.
G4186Z 18" Bandsaw