Relay Management - Alcatel Temporis IP80 User Manual

4.8.

Relay management

1: Relay mode:
Possible values are 1 to 5, with the following meaning :
1: trigger mode: the relay is activated by the called party for the "Relay closing" time
duration (eg: electrical locks, door opening ...). If the called party is using a phone, he
must dial the corresponding code. By default 55 for the relay 1 and 66 for the relay 2.
2: Camera mode: The relay is activated automatically during the call and released
immediately when the call is over (eg: external camera)
3: Lighting mode: The relay is activated automatically during the call and released after
the "Relay closing" timeout starting from the moment the call is over (eg: external
lighting)
4: Bell mode: The relay is activated when you press the button and released after the
"Relay closing" timeout (eg: external bell).
5: Sequential opening mode (only for relay 2): in this mode the relay 2 is activated some
time after the relay 1 has been released.
2: Activation code from phone: DTMF code to be dialed from a phone during the conversation
which will trigger the relay.
3: Duration of relay closing in seconds (2 digits [01-99] )
4: Incoming call Control: to prohibit the relay control by an incoming call when the relay is already
in operation.
5: Delay (in seconds) between the release of relay 1 and the automatic activation of relay 2 when
the relay 2 is configured in mode 5 (2 digits [01-99] ).
Temporis IP80 User's guide
1
3
4
V1.0
2
5
Page 15