Draining The Water - Sinclair CFO-12E User Manual

Operation

Draining the water

If the drainage tank becomes full (approx. 5.5 liters), the "
stops automatically. Empty the water from the drainage tank and discard it.
Drainage steps
1. Remove the drainage tank
Lightly pressing on the sides of the tank with
both hands, pull it gently out.
Take hold of the handle, and then remove the tank,
discard the water.
" lamp lights to alert the user, operation
Notation for drainage
Do not remove the bubble packing from the float
on the unit, in order to prevent water from leaking
from the water tank onto household furniture. This
can cause electrical shock and/or short-circuiting.
If the drainage tank is dirty, wash it with cold or
lukewarm water. Do not use detergent, scouring
pads, chemically treated dustcloths, gasoline,
benzene, thinner, or other solvents to clean it, as
these can scratch and damage the tank and cause
water to leak.
When place back the drainage tank, press the tank
firmly into place with both hands. If the tank is not
positioned properly, the Ò Tank FullÓ sensor will
be activated, and the dehumidifier will not operate.
Check to make sure the guards are firmly attached
to the tank. If they are not, the drainage tank will
be harder to remove.
Wait at least 30 minutes before removing the drain-
age tank, in order to prevent the water which still
in the cooling unit from dripping out on the base
plane. (If water has dripped, wipe it up.)
- 9 -