Removing Collected Water - Sinclair CFO-20N Operation Manual

USING THE DEHUMIDIFIER.
Always make sure the water bucket is locked into place on the dehumidifier.

Removing Collected Water

There are 2 ways to remove collected water:
Use the bucket.When the bucket is removed,
the unit will shut off. Empty and replace the
bucket.
NOTE:Hold bucket with both
hands when emptying.
Do not use the hose if using the
Important:
water tank to collect water. When the hose
is connected, water will be drained out through
it onto floor instead of into the tank
NOTES:
Do not remove the bucket while the unit
is in operation or it has just stopped.
Otherwise it may cause some water to
drip from the draining pan.
The bucket must be in place and securely
seated for the dehumidifier to operate.
Water Level
The dehumidifier will turn off automatically
when the bucket is full, or when the bucket is
removed or not replaced in the proper position.
.
The bucket must be replaced in the proper position for
the dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the
proper position.
-5-
Use a hose.Water will automatically
flow into a floor drain by attaching a
14mm inner diameter hose (not included).
Open the drain cover on the side of
1.
the unit.
Thread the drain tie-in (supplied) onto
2.
the nozzle.
3.
Connect the hose to the drain tie-in.and
lead it to the floor drain.