Sinclair CFO-12E User Manual page 12

Operation
Draining the water
Continuous drainage of water
The unit has a continuous drainage port. Using a commercial hose (with an inner diameter of 15mm), the
water in the drainage tank can be continuously drained out of the continuous port of the unit. When setting
up the equipment for continuous drainage, always stop operation first and unplug the power supply plug.
1. Disconnect the drainage tank and open the con-
tinuous drainage port.
Use nippers or a similar tool to cut away the continuous
drainage port in the side of the main unit.
2. Push the hose into the continuous drainage port
Pass a commercial hose (with an inner diameter of 15mm)
through the continuous drainage port, and press it firmly
into the drainage port in the main unit, make sure water
does not leak. The level height of drain piping should al-
ways be not higher than the one of the drainage port, also
drain piping should always be not plugged up, so the con-
densed water can be drained out successfully.
3.Return the drainage tank to its original position
Check the hose periodically to make sure it is still connected
and has not been obstructed.
- 10 -