Scnl; Beep; Rsav; Lamp - Yaesu VXA-100 Operating Manual

SCNL

Function: Scan Lamp On/Off (while paused)
Available Values: ON/OFF
Default Setting: ON
If you set this function to "ON," the lamp will be
illuminated whenever the scanner stops.

BEEP

Function: Keypad Beeper on/off
Available Values: ON/OFF
Default Setting: ON
If you do a lot of scanning, you may wish to set this
Menu item to "Off," as the Beeper will be heard each
time the scanner halts.

RSAV

Function: Receive Battery Saver
Available Values: ABS/1:1 ~ 1:10
Default Setting: ABS (Automatic Battery Saver,
based on activity on receiver)
The setting of 1:10 will promote the greatest conser-
vation of battery capacity, but the receiver's response
time to incoming calls will be slowed somewhat.
Note: This feature does not operate during Scan or
Dual Watch.
34
( )
MENU "SET"

LAMP

Function: LCD Illumination Mode
Available Values: KEY/TGL/5
Default Setting: 5
In the "KEY" mode, the lamp will be activated for 5
seconds when a front panel key is pressed.
In the "TGL" mode, the LAMP switch toggles the
lamp on and off.
In the "5" mode, the LAMP switch activates the
lamp for 5 seconds.
SFT
Function: CPU clock shift
Available Values: ON/OFF
This is used only at the factory. Do not change this
Menu item's setting!
PRTM
Function: Priority Checking Time
Available Values: 05/10/15/20/25/30 (x0.1 sec)
Default Setting: 20 (2 seconds)
This Menu item allows you to define how often the
Priority Channel will be checked for activity.
Note: The Dual Watch Polling time is 500 mS (fixed).
VXA-100 A
MODE
P O
VIATOR ILOT PERATING
M
ANUAL