Copy - NAD T 785 Owner's Manual

5 Press the [AMP] button in the DEVICE SELECTOR page.
6 Use [ ] to select between "No" (desired punch-through key will
not be saved) and "Yes" (desired punch-through key will be saved and
process is completed).
NOTE
The HTRC 1's [VOL] keys are pre-programmed as "punched-through"
for all Device Select pages: [VOL] will operate the NAD's master-volume
regardless of the currently selected device. The [SURR], [CENT] and [SUB]
CHANNEL VOLUME controls similarly are pre-programmed as punched-
through.
PUNCH-THROUGH MACRO
A stored macro command can also be "punched-through. " This provides a
way to execute a macro with a single keys press.
Example: Punch-through macro command stored at [0] to the [RTN] key
of [BD] page.
1 Press [BD] in the DEVICE SELECTOR page.
2 Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [
scroll to "Pun Thr".
3 Press [ENTER].
4 Press [RTN] button.
5 Press the [MACRO] button in the DEVICE SELECTOR page.
6 Press [0] button – this is the key where the macro command is
associated.
7 "Save" and "No?" are shown in the display. Use [
"No" (desired punch-through macro command will not be saved) and
"Yes" (desired punch-through macro command will be saved and
process is completed).
EXECUTE PUNCHED-THROUGH MACRO
To recall the punched-through macro command as above example, press
[BD] in the DEVICE SELECTOR page and then press [RTN] – the macro
command will then be executed.
Refer also to the "MACRO" section below for information on how to setup
macros.
USING THE HTRC 1 REMOTE CONTROL

COPY

This function allows you to copy functions from one key to another.
Example: Copy "PAUSE" [ ] command from DVD page to the AMP [ ]
button.
1 Press [AMP] in the DEVICE SELECTOR page.
2 Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [
scroll to "Copy".
3 Press [ENTER].
4 Press [DVD] from DEVICE SELECTOR page.
] to
5 Press [ ] button - this is the function key that will be copied.
6 Press [AMP] from DEVICE SELECTOR page.
7 Press [ ] button - this is the button where the function will be copied.
8 Use [ ] to select between "No" (desired function key will not be
copied) and "Yes" (desired function key will not be copied and process is
completed).
NOTE
The copy and punch-through functions are similar. However, if you copy a
command and then subsequently delete, or over-write the original (source-
key) command, the copied-to key's command remains unchanged. If you
] to select between punch-through to a command and then delete or over-write the original
key, the punched-through functions also change accordingly.
OPERATION
] to
45