Auto Network Setup - Samsung SNB-2000P User Manual

6. Click [OK].
Manual network setup will be completed.
7. When the manual setup including <IP> is completed, the camera will restart.
If the Broadband Router has more than one camera connected
Configure the IP related settings and the Port related settings distinctly with each other.
Category
IP related settings
Port related settings

M
If the <HTTP Port> is set other than 80, you must provide the <PORT> number in the address
bar of the Internet browser before you can access the camera.
ex) http://IP address : HTTP Port
http://192.168.1.201:10000

Auto Network Setup

Run <IP Installer.exe> to display the camera search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.

M
For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not
support this function.
1. Select a camera in the search list.
Find the MAC (Ethernet) address labeled
on the rear of the camera.
Both the [Auto Set] and [Manual Set]
buttons will be activated.
2. Click [Auto Set].
The AUTO SET dialog appears.
The <IP Address>, <Subnet Mask>,
and <Gateway> will be set automatically.
IP Address
Subnet Mask
Gateway
HTTP Port
VNP Port
TCP Port
UDP Port
Upload Port
Multicast Port
Camera #1
192.168.1.200
255.255.255.0
192.168.1.1
80
60001
60002
60003
60004
60005
Camera #2
192.168.1.201
255.255.255.0
192.168.1.1
10000
10001
10002
10003
10004
10005
English _33