Samsung SNB-2000P User Manual page 55

To set the alarm input
1. Select <Event> - <Alarm input 1> or
<Alarm input 2>.
The Alarm Input setup window appears.
2. When done, click [Apply].
Your settings will be saved.
Input device setup : Select an input
type according to the characteristics
of the alarm sensor on the rear of the
camera.
- Off : Turns off the alarm input setting.
- NO (Normal Open) : It is normally open, but if it is closed, an alarm will be
triggered.
- NC (Normal Close) : It is normally closed, but if it is open, an alarm will be
triggered.
Activation time : You can set a time to execute a specifi c command when an
alarm occurs.
- Always : Always executes the specifi ed command when an alarm occurs.
- Only scheduled time : Executes the specifi ed command when an alarm occurs
only on a specifi ed weekday, or time.
Action : You can set an action to execute when an alarm occurs.
- Alarm output : Set the alarm output port to which the alarm signal is transferred.
- Output duration : Set the period of time to output the alarm signal to the
specifi ed alarm output port when an alarm occurs.
If a new alarm event is detected during the alarm output, the delay time is
recalculated based on the detection time of the recent alarm.
- Alarm image transfer : If you select <On>, you can transfer JPEG images to the FTP
or SMTP server according to the setting in <Event> - <Transfer setup>.
English _55