Bugera 333XL User Manual
Valve amplifiers
Hide thumbs
Also See for 333XL:
- Quick start manual (30 pages) ,
- User manual (12 pages) ,
- Instructions (3 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Bugera 333XL
Summary of Contents for Bugera 333XL
-
Page 1: User Manual
A50-62313-00004 333XL/333XL-212/333/333-212 User Manual... -
Page 2: Important Safety Instructions
Important safety instructions CAUTION: High voltage! Risk of death! High voltages of up to 500 V DC may be present inside the casing for long periods after being disconnected from the mains. To avoid lethal electric shock, do not open the casing. There are no user-serviceable components inside. -
Page 3: Table Of Contents
Control elements ................5 Front panel......................... 5 Rear panel.......................... 6 Footswitch......................... 7 Inside the BUGERA......................7 Wiring the BUGERA ................8 Audio connections ................9 Specifications ................. 10 Warranty ..................11 CAUTION! Please note that high volume levels may cause permanent damage to your hearing and/or your loudspeakers. -
Page 4: Introduction
Discover the sound of the BUGERA and be the equipment was purchased. Should your BUGERA dealer inspired by its versatility. Whatever style you play, this... -
Page 5: Control Elements
Should this be the case, adjust The MASTER control adjusts the volume level of the the GAIN and VOLUME settings so that the BUGERA. First, bring the levels of the amplifier’s three problem does not recur. channels into line and only then specify the overall level with the MASTER control. -
Page 6: Rear Panel
Refer to „Footswitch“ for details. 28 The DAMPING switch lets you specify the damping factor of the BUGERA (only 333 and 333-212). The term „damping“ refers to a feature of the amplifier that affects the signal’s fade-out phase. A high damping factor (HIGH) makes the signal fade out quicker than a low factor (LOW). -
Page 7: Footswitch
The CLEAN switch activates the CLEAN channel. Its 333-212 are supplied with 6L6GC power amp valves LED illuminates when the channel is active. when it leaves the factory. The models 333XL and 333XL-212 incorporate EL34 power amp valves. The CRUNCH switch activates the CRUNCH channel. -
Page 8: Wiring The Bugera
To avoid burning yourself, make all connections while the unit is still cold. The BUGERA amplifier has two paralleled LOUDSPEAKER outputs which are used to connect one or two speaker cabinets. If you only connect one speaker cabinet, be sure that the IMPEDANCE switch is set to match the impedance of the connected cabinet. -
Page 9: Audio Connections
The LEVEL control of the LINE OUT lets you adjust the output level of the BUGERA to the input sensitivity of the mixer. In addition, the speaker signal of the BUGERA is picked up by a microphone and is fed to the microphone input of the mixer. -
Page 10: Specifications
-80 dBV Min. input level -90 dBV Lead channel Nominal input level -80 dBV Min. input level -90 dBV Preamp low-gain input (only 333XL and 333XL-212) Impedance 44 k All levels attenuated by +6 dB Effects send Impedance 47 k or higher Min. -
Page 11: Warranty
Technical specifications and appearance are subject to change without notice. The information contained herein is correct at the time of printing. All trademarks (except BUGERA, the BUGERA logo, and THE SOUL OF VALVES) mentioned belong to their respective owners, and such use neither constitutes a claim of the trademarks by RED CHIP COMPANY LTD nor affiliation of the trademark owners with RED CHIP COMPANY LTD.