Connecting To Dust Collector; Connecting To Power Source - Grizzly G0504 Owner's Manual

Connecting to Dust
Collector
To be effective, the dust collection system that
you connect to the resaw must be able draw a
combined total of at least 1000 CFM at the dust
ports. Note—This number is an approximation
and has been provided for estimation purposes
only.
To connect the resaw to a dust collector:
1. Attach two 4" dust hoses to the dust ports as
shown in Figure 20, and be sure to tighten
the hose clamp to ensure a snug fit.
Figure 20. Dust hose connected to dust port.
-22-
Connecting to
Power Source
If you have performed all of the previous set up
instructions, the resaw can now be connected to
the power source by a qualified electrician.
G0504 16" Horizontal Resaw Bandsaw