Deep Cleaning; Cleaning External Surfaces; Trouble-Shooting - Envion Ionic Pro Compact CA200 Owner's Manual

Deep Cleaning

Noisy functioning (audible loud buzzing sound) is a sign that your Ionic Pro
ionic air purifier is overdue for a complete clean-up of the collection blades and the internal
ionizing wires. The internal ionizing wires must be kept clean to ensure silent and normal
operation.
For deep cleaning, follow both the "TO CLEAN THE COLLECTION BLADES"
& "TO CLEAN IONIZING WIRES" sections.
IMPORTANT: MAKE SURE THE THOROUGHLY CLEANED AND DRIED COLLECTION BLADES ARE PROPERLY INSERTED, THE
REMOVABLE CAP IS BACK IN ITS ORIGINAL POSITION, AND THE WIRE CLEANING MECHANISM IS BACK IN ITS ORIGINAL
POSITION BEFORE RESUMING USE—OR THE UNIT WILL NOT FUNCTION.

Cleaning External Surfaces

Over time, some particles and dust may accumulate on the external surfaces of your Ionic
Pro ® Compact ionic air purifier. If this happens, turn off and unplug the unit. Mix one
ounce of laundry bleach with five ounces of water and apply sparingly with a sponge to wipe
the outer case surfaces. Do not allow water to slip into the internal parts of the Ionic Pro
Compact ionic air purifier as this could damage its functioning and may result in injury to
you. Allow the unit to dry for at least 24 hours before resuming use.
11
CLEANING & MAINTENANCE

TROUBLE-SHOOTING

TROUBLE
Compact
®
Indication/Setting light
not on
Red CLEAN light is on
Excessive noise
generated*
®
Collection blades do not
go back in
Indication light does not
go on
*See "Cleaning & Maintenance" section
REASON TROUBLE-SHOOTING
Machine is unplugged. ON/OFF Check to see if plug is
button has not been pressed. loose. Press the ON/OFF
button.
Too much dust has Turn off, unplug and clean using
accumulated. instructions from the "Deep
Cleaning" section.
Collection blades are jarred or Remove and re-insert
removed suddenly. collection blades and press
"on" button to reset.
Red light may go on if the unit Press "on" button to reset.
just needs to be "reset".
Too much dust has Clean and dry blades and
accumulated or internal parts ionizing wires thoroughly*.
are wet. Keep the machine dry.
Improper orientation. Reverse blade orientation.
Collection blades are not Check to see that the blades are
completely inserted. completely seated in housing.
Wire Cleaning Mechanism is not Check to see that Wire Cleaning
completely inserted. Mechanism is completely
seated in housing.
12
TROUBLE SHOOTING