GE Monogram ZBD6605 Owner's Manual page 23

Questions? PROBLEM
Use this
Suds in the tub (cont.)
problem
solver
Dishes and flatware
not clean
POSSIBLE CAUSE
Too much rinse agent used • Remove any spilled rinse aid.
Improper rack loading
Filter or spray arms dirty
Inlet water temperature
is below 120°F
Air gap is clogged
Water pressure is
temporarily low
WHAT TO DO
For all other models:
• Pump out water by closing the door until
it locks into place.
• Press the NORMAL WASH button, then
press start.
• Wait for one minute, then press and hold
down the START/CANCEL button for
three seconds. Repeat if necessary.
• Reduce rinse aid setting.
• For soft water, rinse aid may be unnecessary.
• Make sure large dishware does not block
the detergent dispenser or the wash arm.
• Assure silverware is not blocking spray arm.
• Clean filters and spray arms according to
instructions on page 20.
• Run tap until water is hot, prior to starting
Chef's Washer cycle.
• Raise the water heater temperature to 120°F.
• Depending on model, use WATER TEMP
HIGH or WATER TEMP SANI option if
suitable for dish load.
• Clean the air gap.
• Turn on a faucet. Is water coming out more
slowly than usual? If so, wait until pressure
is normal before using your Chef's Washer.
23