Table of Contents
Advertisement
RCA Line Output
This pre-amp signal output can be used to connect signal input to an additional amplifier or
crossover at an ease without using splitters
Tri-Mode Capable (Excluding AP700M & AP1000M models)
If so desired the amplifier may be run in stereo and mono at the same time. For example, this
feature would allow you to run a pair of mids and tweeters in stereo and a subwoofer in mono.
Power Light Strip
All California amplifiers are equipped with bright red power light strip in top center of the
amplifier to enhance the appearance of the amp. When the amp is turned on, this red light
strip will come on along with the green power LED on the side panel of the amplifier.
Remote Turn-on
Automatically turns amplifier on when connected to the head unit's remote output. The
amplifier will turn on and off with the head unit to save current consumption. This control also
operates the reset circuit for the amplifier's protection. It must be connected with the head
unit in order to reset protection circuits.
Adjustable Input Sensitivity
Allows you to fine-tune the level matching between your source and the power amplifier.
Power and Speaker Distribution Blocks
Heavy gauge bare wire distribution blocks are provided for maximum power and signal
transfer with minimal resistance.
Impedance Stability
.
For 2 and 4 channel amplifiers, the amp is stable with a 2 ohm or greater impedance load
under stereo mode and 4 ohm or greater impedance load under bridged (mono) mode.
For mono subwoofer amplifiers (AP700M & AP1000M), the amp is stable with a 2 ohm or
greater impedance load.
Fuse(s)
This protects the amplifier against short circuits and excessive current.
4
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the California AP400 and is the answer not in the manual?