StreetStrider Summit 8r Owner's Manual page 10

pole (Fig. 3-8a), then make adjustments and tighten clamps. IMPORTANT: When finished adjusting strider poles, make sure
the upper right and left pole positions are mirror images (Fig. 3-8b). Strider poles can be readjusted to try different positions
when riding the StreetStrider. When the strider poles are aligned, the hand brake lever and twist grip shifter positions can also be
adjusted to suit the rider. The brake lever clamp requires a 5 mm hex wrench and the right side twist grip shifter requires a 3 mm
hex wrench for adjustment (Fig. 3-8c). Once the brake levers are positioned, rotate the twist shifter so that the gear number is
facing the rider, then tighten.
Installing the Rear Wheel – Sprinter 3r (see next section for Summit 8r)
Figure 3-9. Installing the rear wheel – Sprinter 3r
Figure 3-10. Installing the rear wheel – Sprinter 3r (con't)
Figure 3-11. Installing the rear wheel – Sprinter 3r (con't)
Unscrew the hub nuts on each side of the rear wheel so there is a ~1 cm section of axle thread showing (Fig. 3-11a) that will be
slid into the frame dropout slot. Open the rear brake with the quick release lever so the tire can slide between the brake pads
(Fig. 3-11b). With the wheel partly inside the frame, thread the chain around the hub sprocket (Fig. 3-11c).
Figure 3-12. Installing the rear wheel – Sprinter 3r (con't)
Raise the rear wheel so the exposed axle slides into the frame dropout, making sure the yellow non-turn washer on the left side
is outside the dropout (Fig. 3-12a). Pull the wheel rearward to make the chain taut and center the wheel, then tighten the hub
nuts using the 15 mm open end wrench (Fig. 3-12b). Insert the push rod, located in the screw bag, into the right side of the rear
axle (Fig. 3-12c).
10 StreetStrider Summit 8r / Sprinter 3r Owner's Manual
Remove ties and packing material from the
rear triangle (Fig. 3-9a) and from the chain
(Fig. 3-9b). Thread the shifter cable along
the frame (Fig. 3-10a) and through the
hanging loop of chain (Fig. 3-10b), and
secure the cable to the cable boss (Fig. 3-
10c) with the black plastic cable clips
located in the screw bag.