Grizzly G0449 Instruction Manual page 43

37" drum sander
Hide thumbs Also See for G0449:
Table of Contents

Advertisement

16. Remove the control panel and set it to the
side without disconnecting any wiring.
17. Loosen the strain relief on the conveyor
motor cord, and disconnect wiring inside the
conveyor motor junction box.
18. Remove the conveyor feed motor. The sand-
er should now be disassembled as shown in
Figure 49.
Figure 49. Drum sander disassembled
to Step 17.
19. Using four strong people (or a forklift w/
straps), carefully lift the table off of the drum
sander cabinet, as shown in Figure 50.
Note: When removing the table, be careful
with the ball thrust bearings located under
the table elevation shafts (part #78 in the
breakdown drawing), as they can be easily
knocked onto the ground.
Figure 50. Lifting the table off of the drum
sander cabinet with four people.
G0449/G0450 37" Drum Sander
20. Remove the brackets from the left side of the
table and remove the belt (see Figure 51).
Note: Leave the front pillow bearing connect-
ed to the bracket, but disconnect that bracket
from the table.
Figure 51. Conveyor belt removed from table.
21. Install the new belt and reassemble the drum
sander by reversing the disassembly steps.
22. After reassembly, adjust the drums and pres-
sure rollers to their proper settings. See Drum
Adjustments on Page 33 and Pressure
Roller Height on Page 36.
-41-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

G0450

Table of Contents

Save PDF