Installing Handwheel; Dust Collection - Grizzly G0449 Instruction Manual

Installing Handwheel

Components and Hardware Needed:
Handwheel ........................................................ 1
To mount the handwheel:
1. Place the handwheel over the shaft shown
in Figure 11 and tighten the setscrew in the
handwheel hub.
Figure 11. Handwheel location.
-18-

Dust Collection

This drum sander requires a minimum of 1600
Qty
CFM at the sander. We recommend using a dust
collection system that produces a minimum of
2000 CFM. A fine layer of dust will be present on
your stock as it comes out of the sander. This is
normal.
Components and Hardware Needed:
Dust Hoses 4" (not included) ........ Length Varies
Hose Clamps (not included) .......................Varies
Dust Collection System (not included) ...............1
To connect the dust ports to a dust collector:
1.
Attach 4" dust collection hoses to the dust
ports shown in Figure 12 and secure them
with hose clamps.
Figure 12. Dust port locations.
G0449/G0450 37" Drum Sander
Qty