Program Mode - WowWee Roboreptile User Manual

prOgraM MOE
IMPORTANT
By entering Program Mode, the existing program (should one be present) will immediately be cleared.
A 20-step program can be made using the Direction and
Animation buttons.
To ENTER Program Mode press the Program Mode Button.
Roboreptile will get up on his back legs and will not move once
in Program Mode.
Programming your Roboreptile
The user can choose a combination of controller commands
from all three layers of the controller to form a program.
There are 20 steps in each program. When the user enters a step
successfully, a confirmation will be sounded. When Roboreptile
is unable to perform a step, a denial will be sounded.
The following functions cannot be included in the program:
– Demo Modes – Feed
– Guard Mode – Stop
– Volume Control – Roam
Playing the Program
The user can replay the program at any time by pressing the
Program Play button.
Exiting Program mode
To exit Program Mode immediately, press Program Play.
Roboreptile will perform a program if one is stored.
To exit Program Mode, the user can leave Roboreptile
for approximately 30 seconds
Without entering any commands, Roboreptile will enter
Free Roam Mode after about 60 seconds. If commands have been
entered, Roboreptile will perform the routine.
NOTE
Pressing STOP will sound a denial. It will not exit Roboreptile from Program Mode, as it does not register
as a programmable command.
Clearing the Program
Pressing Program Play immediately after entering Program Mode
will eliminate the program, as will refraining from entering any
program steps.
NOTES
Press the Feed button will interrupt Program Mode. Roboreptile will start his Feed routine.
The program memory is cleared when Roboreptile is turned off.
It is not recommended to use the "Body Down" function in a program sequence.
Roboreptile will automatically start in the 4-leg position for most actions.