Table of Contents
Advertisement
1. Clean the air filter
When cleaning, gently tap the air filter or remove the dust with a vacuum cleaner, or you
can put the air filter in warm water ( ≤ 40
to brush it, and then wash with clear water.
Attention
a. The air filter should not be exposed directly to sun of fire, to avoid deforming.
b. The air filter should be fixed before starting the dehumidifier.
VI. TROUBLES AND COUNTERMEASURES
Problem
Unit does not operate
Unit
does
not
operate
although there is no power
problem
Capacity reduction
Drained water leaks out
VII. POINTS TO REMEMBER
1. Its outlet dry air temperature is higher than inlet air temperature, but outlet air's
moisture content is lower. When the dried air is sent to one space, it soon will mix with
the space's wet air and absorb the humidity. So, normally, space's humidity will decrease
after half an hour of operation. However, temperature of the space will be little bit higher
if the space uses dehumidifier for drying for a long time.
2. Before being used, the whole set of dehumidifier should be earthed.
3. After opeing the packing, pls. check whether there is any damage of the machine due
to transport, whether the connecting line of each electric parts is tip-off, loosen or cut off.
It there is, please try to repair it.
4. Dehumidifier should be avoided from sunlight and other heat sources, such as burner.
Please let its surrounding air be circulating, especially inlet air entrance.
5. Drain pipe should lead to cloacae lengthened by rubber pipes, so that coagulate water
can be moved out. If no cloaca, then the coagulate water have to be drained outside
6. Turn the knob of humidity controller to required value of relative humidity, then the
compressor can start or stop based on this value, circulating fan will operate continuously.
IKENO INDUSTRIAL DEHUMIDIFIER - USER'S MANUAL - Model ID-series
- 8 -
o
C, add a little neutral detergent ) to wash it or
Cause
Power failure
Power
source
is
switched
on
not
plugged
Fuse is broken
Room humidity has lower
than
set
humidity
humidistat
Air filter dusted
Drain pipe is blocked
Solution
Check and solve problem
not
well
Turn humidistat to higher
in
value to see whether the
unit re-operate, the reset
initial position
Clean air filter
Remove the front panel and
wipe off dirt from the pipe
Subject to change without prior notice
Advertisement
Table of Contents
