Table of Contents
Advertisement
III. INSTALLATION
1. Receiving inspection
Remove the shipment packing and inspect unit to ensure that no damage has occurred
during transportation and storage. Any visible damage must be reported to nearest Ikeno
representative.
2. Working Environment
+ The unit should be installed stably. There should be one meter of space in front of the
inflow and outflow. There should be no large obstacle around it.
+ The machine set should be far from heat source and inflammable gas.
+ The condensed water could be drained out of the room or into a pail.
+ It is advisable to not to install it in a place of heavy dust or serious pollution.
3. Power source
+ The power should be supplied with a special wire.
+ Provide automatic circuit breaker.
+ There should be reliable electrical grounding.
4. Other requirement
+ Skilled professional personnel should perform maintenance of the unit.
+ Parking inclination of the unit should not exceed 10
IV. OPERATION PROCEDURES
V. MAINTENANCE
* Switch off the power source before maintenance.
* Due to the accumulation of dusts, the air filter should be cleaned to avoid effecting
dehumidifying and going wrong periodically, at least once a month.
IKENO INDUSTRIAL DEHUMIDIFIER - USER'S MANUAL - Model ID-series
- 7 -
1. Turn on
+ Switch on the main insulator (provided by contractor).
+ The power lamp (2) is on.
+ Turn humidistat knob (5) to desired value
+ Push ON button (3) to start the unit (Notice: in case the
unit has just been stopped for less than 3 minute, the delay
relay keeps the turn on for 3 minutes to protect
compressor).
+ The Operation lamp (1) is on and unit starts working.
2. Turn off
+ Push OFF button (4) to turn the unit off.
+ Switch off main insulator
Notice !: Vapor pressure gauge (6) used to check
compressor performance (technical personal only).
o
.
Subject to change without prior notice
Advertisement
Table of Contents
