Advertisement
Quick Links
Advertisement
Related Manuals for Hartke AK410
Summary of Contents for Hartke AK410
- Page 1 BASS ENCLOSURES SERIES AK410 AK115...
- Page 3 Copyright 2012, Samson Technologies Corp. Hartke 45 Gilpin Avenue Hauppauge, New York 11788-8816 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 631-784-2201 www.hartke.com...
-
Page 4: Table Of Contents
About Impedance and Power Handling ..... . . 3 Connecting the AK410 and AK115 ......4 Using The High Frequency Level Control . -
Page 5: Introduction
The AK Series is new line up of bass speaker enclosures featuring Hartke’s new AK paper cone bass transducers. This manual covers two models, the AK410 and AK115. The AK410 is configured with four 10-inch, 125-watt bass drivers, with a 1-inch titanium compression driver in a dual chambered, sealed enclosure, with 500 watts of power handling. -
Page 6: Ak Series Enclosures Features
AK Series Features AK410 Features • 4 x 125 watt 10-inch, heavy-duty, paper cone low frequency drivers with ceramic motor • 1-inch, titanium, high frequency com- pression driver with level control • Sealed, two chamber enclosure • 500 Watt Power Handling •... -
Page 7: About Impedance And Power Handling
“Series”, the total impedance number is the sum of the speakers individual impedance. The AK410 and AK115 impedance (many audio guys use the made up word “ohmage”, however the correct term is impedance) is 8 Ohms. So, when two AK410's or AK115’s are connected together in parallel, the total impedance... -
Page 8: Connecting The Ak410 And Ak115
Be sure to make your connection with un- shielded speaker cable. Connect the Amplifier Output to the speaker Input on the AK410’s or AK115’s rear jack- plate. Using the EXTENSION Output The AK410 and AK115 provides a... -
Page 9: Using The High Frequency Level Control
Using The High Frequency Level Control Using The High Frequency Level Control Your AK Series cabinet has a control used to adjust the level of high frequency compression driver. The switch has three positions, ON, -6dB and OFF. When the switch is set to OFF, the compression driver is completely out of the circuit and off. -
Page 10: Specifications
Specifications AK410 Specifications Type 2 chamber, sealed enclosure System Impedance 8 Ohms Low Frequency Drivers 4 x 125 watt, 10", paper cone drivers High Frequency Driver 1" Titanium Compression Driver with Level Control Power Handling 500 Watts RMS Frequency Response... - Page 12 45 Gilpin Avenue Hauppauge, New York 11788-8816 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 631-784-2201 www.hartke.com...
Need help?
Do you have a question about the AK410 and is the answer not in the manual?
Questions and answers