Table of Contents
Advertisement
OPERATING THE GS6
With everything connected and powered up, the GS6 is ready to play!
POWER ON/OFF
1. Set the Power switch to the ON position.
ON
1. If the ON/AUTO switch is set to ON, and the Power switch is set to the ON position, the GS6 amplifier will always be ON
and ready to play.
AUTO
1. If the ON/AUTO switch is set to AUTO, and the Power switch is set to the ON position, the GS6 amplifier will sense an audio
signal on the Line IN and automatically turn ON.
OFF
ON
1. If the ON/AUTO switch is set to ON, the Power switch can be used for manual power OFF if desired.
AUTO
1. If the ON/AUTO switch is set to AUTO, it is not necessary to turn the GS6 OFF. The audio sensing circuit will automatically
turn the amp OFF (standby) when no audio signal has been detected for more than five minutes. The Power switch can be
used as a manual power off if desired.
VOLUME
Set the Sub Volume on the GS6 using the following steps. There may be some trial and error in getting just the right levels, and
you may want to make adjustments to the settings as you become familiar with the sound of the GS6.
Once the Sub Volume has been set on the GS6, use the volume control on the source to control system volume.
SUB VOLUME
1. With a source playing at a normal listening level, adjust the Sub Volume knob until the low frequency sound (bass) playing
from the GS6 subwoofer sounds natural and balanced with the main speakers.
2. Play different types of music to find a good overall setting that will sound good with different types of music.
3. Once the Sub Volume has been set on the GS6, use the volume control on the source to control system volume.
10
Advertisement
Table of Contents
