SAFETY INSTRUCTIONS RISK OF ELECTRIC SHOCK APPLICABLE FOR USA, CANADA OR DO NOT OPEN WHERE APPROVED FOR USAGE RISQUE DE CHOQUE ÉLECTRIQUE N'OUVREZ PAS CAUTION: To reduce the risk of electric CAUTION: TO PREVENT ELECTRIC SHOCK, shock, do not remove cover (or back). MATCH WIDE BLADE PLUG TO WIDE SLOT, No user-serviceable parts inside.
The GS6 can be used with a computer line output or can be used with the pre-amp (variable) output of a stereo audio receiver or amplifier to enhance low frequency sound.
3. SUB VOLUME - Adjusts the audio level of the GS6 Subwoofer. This allows the Sub audio level to be balanced with the audio level of the satellite speakers. Adjust until bass is full and natural sounding.
Page 7
GS6 SUBWOOFER REAR PANEL 7. REAR PANEL BASS PORT - Tuned opening in the GS6 cabinet allows air to ‘release’ from the cabinet and enhance low frequency audio. Allow at least 3 inches of clearance to a back wall to allow air to move freely from the port for full bass extension.
Also, if locating the sub next to an equipment cabinet or some other piece of furniture, be sure the grille of the GS6 is at least even with the front of the cabinet so the low frequency sound waves are not blocked and can properly open up into the room.
1. Using a stereo RCA to mini cable terminated with gold ends, connect the L & R Pre-amp OUT on a stereo audio receiver to the Line IN on the GS6 or use a stereo mini-mini for connection to a computer line output. The GS6 will sum the left and right channels into a single sub channel.
POWER ON/OFF 1. Set the Power switch to the ON position. 1. If the ON/AUTO switch is set to ON, and the Power switch is set to the ON position, the GS6 amplifier will always be ON and ready to play.