Subscribe to Our Youtube Channel
Related Manuals for Oracle Audio P1000
Summary of Contents for Oracle Audio P1000
- Page 1 ORACLE AUDIO P1000 STEREO POWER AMPLIFIER ORACLE AUDIO TECHNOLOGIES OWNER’S MANUAL...
- Page 2 INTRODUCTION Thank you for purchasing the Oracle Audio P 1000. Stereo Power Amplifier. Please read carefully the instructions before using the P 1000. This unit is manufactured under strict quality control and must be used properly for safety and optimal performance. The Oracle Audio P 1000 is a power amplifier with 200W of output in STEREO mode.
- Page 3 CAUTION The P 1000 voltage is preset according to the country used. If you move after purchasing the P 1000, please contact Oracle Audio Technologies to modify your voltage wiring for proper use. To reduce the risk of fire or electrical shock, do not put the P 1000 in water, humidity or near a heat source.
- Page 4 FEATURES The Oracle Audio P 1000 is specially designed to guarantee the full fidelity of high-end sound reproduction for a lifetime usage. Junction FET Input Proprietary Feed-back circuit on the Power Transistors with Non-polar Capacitors for the improvement of the Bass Impact Push-pull Parallel Output Circuit 200W/Ch at 8 Ohm (stereo mode) 600W at 8 Ohm (bridged monaural mode): switch selectable from the rear panel...
-
Page 5: Stereo Amplifier
CONNECTION STEREO AMPLIFIER [Fig. 1] Unbalanced Connection... - Page 6 [Fig. 2] Balanced Connection Connection to the preamplifier should be made with unbalanced interconnect cable or balanced interconnect cable. Check if the Stereo & Bridged switch on the back panel is in position ‘STEREO’. When using an unbalanced cable, make sure that the input selection switch for both left &...
-
Page 7: Bridged Mode
is ready for normal operation. BRIDGED MODE [Fig. 3] Balanced Connection The P 1000 can be operated as a monaural amplifier. As an input terminal, only the ‘LEFT’ input is operational. Check if ‘BRIDGED’ switch is selected for the bridged monaural application. As directed, only ‘(+)’... -
Page 8: Specifications
SPECIFICATIONS INPUT SENSITIVITY 0.83 V, 200W/8 Ohm SIGNAL TO NOISE 10-20 kHz, -100 dB 0.005%, at 30W, 8 Ohm FREQUENCY RESPONSE 10Hz - 45 kHz, +-3dB POWER OUTPUT 200W/Ch at 8 Ohm 350W/Ch at 4 Ohm 600W/Bridged Mono SIGNAL INPUT RCA/Unbalanced, 1 Pair XLR/Balanced, 1 Pair 12V Trigger (RCA), 1 Ea... -
Page 9: Warranty
WARRANTY Oracle Audio Technologies carries a 3-year warranty on new products. Always contact your authorized Oracle Audio dealer for service The Oracle Audio P 1000 must not have been modified in any circumstances or the warranty will be voided. ORACLE AUDIO TECHNOLOGIES INC Made in Canada www.oracle-audio.com...
Need help?
Do you have a question about the P1000 and is the answer not in the manual?
Questions and answers