Installation - Crown FM2000A User Manual

2.5 Installation

1. Mount the units in an appropriate 19–inch wide cabinet. The power supply
must be installed directly below the power amplifier for the included cables
to reach their respective connectors (see illustration 2–4 below).
Note: The PS2000 weighs approximately 43 pounds (19.5 kg); the
PA2000, approximately 57.5 pounds (26.1). Use help to install.
2. Ensure that the PS2000 power switch is off, the circuit breakers of the 240
VAC source on the back panel are off, and the AC connector is not plugged in.
3. Install the exciter source (such as a Crown Broadcast FM100) according to its
instructions.
4. Connect the RF input cable from the exciter source to the N connector on the
back of the PA2000.
5. Connect the RF output cable (from the antenna) to the 7/8 EIA or 7-16 DIN
connector on the back of the PA2000.
6. Connect one end of the supplied control cable to the 9–pin D-sub connector
on the PA2000.
7. Connect the other end of the control cable to the 9–pin D-sub connector on
the PS2000.
+ DC Input
Ground Screws
DC Input
PA2000
+ DC Output
DC Output
PS2000
Illustration 2–4 Rear Panel Connections
Installation
RF Monitor
(Optional Connection)
Air Intakes/Filters
RF Output
Air Exhaust Vents
RF Input
Remote I/O
Control
Circuit Breakers
OFF OFF
Fans
Power
Control
240 VAC IN
2–5