Table of Contents
Advertisement
Verify and, if needed, adjust the height of the pressure rollers as follows:
For the following adjustments, we recommend that
you use a 1 mm shim and feeler gauge
made gauge block
The gauge block can be made by following the di-
mensions shown in
1.
Place a gauge block
sanding belt installed on), then place a 1 mm
thick shim or feeler gauge
block .
3.
Place the gauge block
the rear pressure roller
block should be in full contact with the pressure
roller
5.
Repeat step 3 and, if needed step 4 for the right end of the rear pressure roller then for both ends of the front
pressure roller.
and a home
made of hardwood.
.
under the drive roller (with
on top of the gauge
under the left end of
. The top of the gauge
2.
Adjust the height of the sanding head so that the
sanding belt is in full contact with the top of the
shim. Then tighten the locking handle
the sanding head in position and remove the
shim.
LOWER
RAISE
4.
If needed, adjust the height of the pressure roller
with the supplied 2 mm allen key by turning the
adjustment screw
.
to secure
CLOSE-UP
17
Hide quick links:
Advertisement
Table of Contents
