Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE COMPLE-
TED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL INSTRUCTED TO DO
SO.
INSTALL THE SIDE AND REAR EXTENSION TABLES
The extension rods
are covered with a protective coa-
ting that helps prevent rust from forming during shipping
and storage.
1.
Remove the protective coating on the support
pipes
by rubbing with a rag dipped in kero-
sene, mineral spirits or paint thinner.
Note: Handle and dispose of potentially flammable sol-
vent soaked rags according to manufacturers' safety re-
commendations.)
3.
Secure with the washers and hex nuts (previously
removed) using the supplied 19 mm combination
wrench and a screwdriver as shown in
INSTALL THE SANDING BELT
1.
Push on the red button on the latch
left side door.
10
LARGER VIEW
2.
Remove the two lock nuts and washers
extension rods located at the rear of the sander,
then install one of the two extension tables
the extension rods.
4.
Repeat with the second extension table on the left
side of the sander as shown in
.
Note: Remove and dispose of the humidity absorbing si-
lica packet
to open the
2.
Loosen the lock knob
REAR VIEW
REAR VIEW
.
located inside the drums housing.
.
from the
on
Hide quick links:
Advertisement
Table of Contents
