Setting Up The Gateway; Connecting A Computer To The Gateway - ActionTec GT701-WG User Manual

Setting Up
the Gateway
The instructions that follow parallel the steps contained in the Actiontec Installation
™
Buddy , which provides a visual guide to setting up the Gateway. It is recommended
the user run the Installation Buddy first, before attempting any other procedures.
To set up the Gateway, it must be connected to a computer, and then configured.
After connecting this first computer, other computers can be added to the network
via , Ethernet, or wirelessly (see "Setting Up a Network" on page 69).
USB

Connecting a Computer to the Gateway

Connecting a computer to the Gateway for setup involves three basic steps: initial
setup, plugging in the Gateway's power cord, and connecting the Gateway to the
computer.
Connecting Via Ethernet
1. Insert the Installation
Installation Buddy starts automatically. Wait until the following screen
appears, read the on-screen instructions, then click Next.
in the
CD CD-ROM
7
drive of the computer. The
2