Maxtor OneTouch User Manual page 69

4. Open Retrospect Express.
The Retrospect Express Directory window will open.
5. Click Restore.
A window will appear asking you to 'Select the restore type'
6. Select Restore an entire disk and click OK.
The 'Accessing more backup sets' window will appear asking
you to open an existing catalog file or rebuild one.
7. Click Open.
Find and select the system backup set on your Maxtor
OneTouch Drive.
8. Click Open.
Your system backup set should appear in the top part of the
Restore from Backup:Source window. Make sure it
is selected.
9. Click OK.
The Destination Selection window will now appear, asking
you to choose a 'Destination for restore.'
Make sure Restore Entire Disk is selected. and select the
drive that you want to restore your system to (your Macintosh
hard drive where the system was originally installed).
10. Click OK.
A window will appear asking you if you really want to restore to
the drive you selected, replacing it's entire contents.
11. Click Replace.
Retrospect will scan your system (This may take a
few minutes).
The Restore from Backup window will appear, allowing you to
confirm the source (your OneTouch drive) and the destination
(your Macintosh hard drive) for the restore.
12. Click Restore.
A window will appear asking you: 'Really Execute?'
13. Click OK.
(If the 'Really Execute?' window appears again, click OK.)
Retrospect will begin to restore your system.
This process may take several minutes.
When Retrospect finishes, you should see the message:
'Execution completed successfully.'
You can view the Log to make sure that all of your files were
restored by going to the Window menu and selecting Log.
14. Quit Retrospect, by going to the File menu and selecting Quit.
15. Restart your Macintosh.
If the system restore was successful, you should find all of the files
that you originally backed up. If not, make sure that you understand
Disaster Recovery 63
5