Ground Filter - White's Spectra V3i Owner's Manual

Ground Filter -

• Filtering out ground minerals allows deeper penetration (detection depth) in mineralized grounds and
also determines the ideal search coil or loop sweep for optimum performance. Less ground fi ltering in low ground
mineral areas increases depth, however, doesn't penetrate high mineral ground well. By adjusting ground fi ltering
the Spectra can be optimized for the regional ground conditions and search coil sweep speed. Use ARROW Left &
Right to select custom ground fi ltration. Lower fi lters (5.0 Hz Band) favor slower search coil sweep speeds. Higher
frequency selections (12.5 Hz High) tend to favor faster search coil sweep speeds.
• Modern metal detector ground fi ltration, because it is no longer a specifi c set of components that equal a
specifi c fi lter, has never been well described nor understood. Modern designs are better described by their speed
(Hz) rather than their quantity or cycles. The ideal setting for your ground type is the one that offers the greatest
depth penetration that also works best with your personal and typical search coil sweep speed.
• The ideal setting for your search coil sweep speed and habits may not be the best for another person in
the same grounds.
• Typically the lower number Hz are better suited for slower search coil sweep speeds. The BAND (full-
range version) of each fi lter speed works better for lower ground mineral conditions, and higher external electrical
interference. The HIGH (high pass version) is better suited to higher ground mineral conditions, and lower electrical
interfference.
• 5.0 Hz Band Pass – Slowest search coil sweeps and lowest ground mineral types.
• 5.0 Hz High (High Pass Filtering) - Slightly higher ground mineralization.
• 7.5 Hz Band Pass - Slow to medium search coil sweep speeds and low to medium
ground mineralization.
• 7.5 High (High Pass Filtering) - Medium to high ground mineralization.
• 10.0 Hz Band Pass - Normal to brisker loop sweep speeds and high ground
mineralization. (Preset for most factory programs)
• 10.0 Hz High (High Pass Filter) - Even higher ground mineralization.
• 12.5 Hz Band - Extreme ground mineralization with relatively quick loop sweeps.
• 12.5 High (High Pass Filter) - Even more extreme ground mineralization.
• A normal search coils sweep rate is 2 seconds from left to right, and two seconds returning from right to
left, best suited to average ground mineralization and the 10.0 Hz settings.
Complete Guide to Spectra V3
pg 33
i
®
B B
A A
S S
I I
C C
M M
E E
N N
U U