Download Print this page

Features; Care And Cleaning - Electrolux 88042 Use & Care Manual

Electric & gas dryer

Advertisement

Drying Procedures

Features

Care and Cleaning

Clean lint screen after every load.
(Con't)
4. Close the dryer door and select the cycle, temperature, dryness level,
options and features desired.
See Operating Instructions for your specific model information.
5. Press START to begin the cycle.
To add or remove items when the dryer is running open the door. The
dryer will stop when the door is opened. Allow the drum to come to a
complete stop before reaching inside.
• Close the door and press START to resume the cycle.
6. When the cycle ends, remove items immediately and hang or fold.
Cycle Signal
A signal will sound at the end of the cycle and periodically during Wrinkle-Rid.
Drum Light
A drum light will come on whenever the door is opened to illuminate the dryer drum
during loading and unloading. Closing the door turns off the light.
Reversible Dryer Door
Your dryer is equipped with a reversible door. The door can be hinged on the right
or left side. Refer to the INSTALLATION INSTRUCTIONS for directions on changing
the door.
with the basic warnings listed in Important Safety Instructions and those listed
below.
Before cleaning the dryer interior, unplug the electrical power cord to avoid
electrical shock hazards.
Do not use any type spray cleanser when cleaning dryer interior. Hazardous
fumes or electrical shock could occur.
Inside
Clean the lint screen after every load. Lint build-up in the screen restricts air flow,
which causes longer drying times. The screen is located at the bottom of the door
opening. Remove by pulling straight up. Remove the lint and replace the screen.
CAUTION - Risk of Fire - A clothes dryer produces combustible lint. The dryer
must be connected to an exhaust outdoors. Regularly inspect the outdoor
exhaust opening and remove any accumulation of lint around the outdoor
exhaust opening and in the surrounding area.
Occasionally a waxy build-up may form on the lint screen from using dryer-added
fabric softener sheets. To remove this build-up, wash the lint screen in warm,
soapy water. Dry thoroughly and replace. Do not operate the dryer without the
lint screen in place.
If the dryer drum becomes stained from noncolorfast fabrics, clean the drum with
a damp cloth and a mild liquid household cleanser. Remove cleanser residue
before drying the next load.
Every 18 months an authorized servicer should clean the dryer cabinet interior
and exhaust duct. These areas can collect lint and dust over time. An excessive
amount of lint build-up could result in inefficient drying and possible fire hazard.
To reduce risk of fire or serious injury to persons or property, comply
5

Advertisement

loading

This manual is also suitable for:

880528807688056980429805298056 ... Show all