Fuse Replacement - American DJ Electra LED DMX User Instructions

Electra LED DMX™
trolling unit and the others will react to the controlling units programs.
Any unit can act as a Master or as a Slave.
1. Daisy chain your units via the XLR connector on the rear of the
unit. Use approved DMX-512 data cables to link your units to-
gether. Remember that the Male XLR connector is the input and
the Female XLR connector is the output. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. The first unit in the chain (master) will use the female XLR connec-
tor only - The last unit in the chain will use the male XLR connec
tor only.
3. Turn dipswitch #1 to the "On" position on the master unit.
4. For the slave units any dipswitch can be set to the "On" position
except dipswitch #1.
5. When running fixtures in Master/Slave configuration you can make
the mirror pan of the 1st and 2nd fixtures contrast the mirror pan
of the 3rd and 4th fixtures.
Example: Four fixtures are linked together. On fixtures 1 and 3 set
the fixture 1 as a master and set fixture 3 as a slave. For fixtures
2 & 4 set them as slaves as well, but also put dipswitch #10 in the
"On" position. The mirror pan of fixtures 1 & 2 will run the same
and the mirror pan of fixtures 2 & 4 will run in contrast to fixtures
1 & 2. This makes a great light show.
6. You can also use the optional UC3 Remote Control. If you want
to use the optional remote control, connect the UC3 controller
to the first fixture in the line (master).
Note: The remote control only operates in Stand-Alone and Master/
Slave modes. If the remote is connected in DMX mode it will not func-
tion. If the units do not receive an active DMX signal, the units will
automatically react to sound in the Master/Slave mode.
Electra LED DMX™
First unplug the power. The fuse holder is located above the power
cord. Using a flat-head screw driver unscrew the fuse holder. Remove
the bad fuse and replace with a new one.
American DJ Supply - www.americandj.com - Electra LED DMX™ User Manual Page 9
© ®
Operating Instructions

Fuse Replacement

Electra LED DMX™
Electra LED DMX™
Stand
Blackout the unit
by
1. Sync. Strobe
Functio n 2.Asynchronism.Stro be
3. Sound Strobe
Sound (pan fast)
Mode
(LED OFF)
American DJ Supply - www.americandj.com - Electra LED DMX™ User Manual Page 10
© ®
DMX Values and Traits
UC3 Control
1. Sync. Strobe
4. Move
2.Asynchronism..Strobe
3. Sound Strobe chase
Auto
Sound (pan slow)
(LEDSlow
(LED ON)
Strobe)