Table of Contents
Advertisement
Wall Bracket Assembly
Install the angle adjustment bracket on the wall as shown in the
figure.
Tighten the angle adjustment bracket by using anchors and screws
orderly from
to
.
If it cannot be installed on the assigned area, install at the nearest
place.
W
a
r
n
i
n
g
W
a
r
n
i
n
g
1. Check the solidity of the wall before the installation. Strengthen the wall and install the bracket if the wall is not firm enough.
2. The supplied screws and anchors are for installing on concrete walls.
3. For the wall of plaster, marble, or steel, use the appropriate screws.
Securely fix the set to the wall. Pull the bracket forward and unfold it. Insert
the bracket to the assigned area of the angle adjustment bracket and tighten
the supplied 8 screws . (Same for both left and right side)
Remove the screws on the LED set. Put the plastic hanger and 4 screws
and firmly tighten on the back panel.
Slim, Normal LED
W
W
a
a
r
r
n
n
i
i
n
n
g
g
1. Mount the product on the wall bracket. Be sure to check on the left and right side to see if it is properly fixed.
2. Be careful when installing the product or adjusting the angle as fingers can be caught in the holes.
3. Be sure the wall bracket is securely fixed to the wall. Falling down the product may cause physical dama
How to Tighten Anchors or Screws
Make a hole in the wall with the drill of
6x50.
Clean up the hole.
Insert the supplied anchor to the hole.
Match the angle adjustment bracket to
the holes on the wall and tighten the
screws .
Use the drill with the required size when making a hole in the wall.
Be sure to follow the directions for the installation to avoid safety
problems.
together
Ultra-Slim Only
Advertisement
Table of Contents
