Advertisement
Installing the Wall Mount
Fix the Angle Adjusters onto the wall as shown by the figure.
②
②
⑤
⑥
⑥
①
①
⑨
⑨
⑪
⑧
⑬
Fix the Angle Adjuster with the anchors and screws ⓐ from ① to ⑭
in sequence as shown by the figure.
If the specified position is not possible, fasten the screws at the
nearest available position,
W
a
r
n
i
n
g
W
a
r
n
i
n
g
1. Check the strength of the wall and if it is insufficient, make sure to reinforce the wall before the installation.
2. The supplied anchors and screws are for wooden and concrete walls.
3. Check the wall and if the wall is made of plaster board, marble or steel board, use the appropriate screws.
Fix the main body onto the wall firmly, pull the angle adjuster forwards, insert
the brackets into the specified position of the angle adjuster and then fasten
the 4 screws ⓑ with the enclosed tool. (For both the left and right sides.)
Remove the screws from the PDP main body, assemble the 4 supplied
plastic hangers and screws ⓒ as shown by the figure and then firmly
fasten them onto the back of the PDP main body.
W
W
a
a
r
r
n
n
i
i
n
n
g
g
1. After hanging the main body onto the wall mount, make sure to visually confirm that all plastic hangers are hanging safely
from the left and right sides.
2. Take care when installing or adjusting the angle because your fingers may be caught by the wall mount.
3. Make sure to fix the wall mount bracket onto the wall because if it is not firmly fixed onto the wall, the main body may fall and it
may cause personal injury.
③
③
⑦
④
⑩
⑩
⑫
⑫
⑭
⑭
※Make sure to use a drill bit with the specified diameter
when drilling the hole.
Failing to do so may result in a safety problem.
Installing the anchors and screws ⓐ
Drill a hole with 6X50 bit.
Clean inside the hole.
Insert an anchor into the hole.
Align the Angle Adjuster to the hole
and insert and fix one of the screws ⓐ
into the hole.
Advertisement
