Advertisement
WIRING
Disconnect battery ground cable before making any power connections.
RED WIRE: +12 volts. Connect directly to battery positive terminal and should be
fused within 18 inches of battery and another fuse where the connection to the
amplifier is made. Remember to use the proper size fuses.
WARNING: USING
OVERSIZED FUSES IS DANGEROUS AND WILL VOID THE WARRANTY!
See specifications for proper fuse size. Do not install power fuse until amplifier
installation is complete.
BLACK WIRE: negative ground. Connect to clean, unpainted metal surface on
car chassis.
RED/WHITE WIRE: Remote turn on lead requires 12 volts; connect to power
antenna lead from radio. When this not available, you may connect to a +12 volts
wire that is on with the ignition on or in the accessory position.
RCA CONNECTIONS: Connect with quality-shielded patch cords from source,
crossover, or any other sound processor.
SPEAKER CONNECTIONS: Slide wire into plug, with wires going down from
plug connections should be as follows: (From Left to Right): first slot Left (-),
second slot Left (+), Third slot Right (-) and fourth slot Right (+) (except 302IQ
©
the terminal strip is in the same order from left to right.) For mono operation use
Left (+) and Right (-). These amplifiers are capable of 2-ohm operation in stereo
or 4 ohms in mono. (See diagrams on next page)
OPERATING THE AMPLIFIER AT LESS THAN THESE RATINGS WILL
CAUSE AMPLIFIER FAILURE AND VOID YOUR WARRANTY.
NOTE: The 652IQ
have internal speaker protection fuses. If there is no output
©
from the amplifier, check these fuses, as your warranty does not cover their
replacement. Replace fuses only with fuses having the same rating.
IMPROPER FUSING WILL DAMAGE YOUR AMPLIFIER!
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
2
LINEAR POWER™ is a trademark of Linear Power, Inc.
Advertisement
