Page 1
™ Fiberstars JAZZ J400C (COLOR), J400AS (AUTO SYNC) Owners Manual Fiberstars 44259 Nobel Drive Fremont, CA 94538 www.fiberstars.com Rev.E • 08/04/04 - 1 - P/N 75-15046-PM...
Page 2
Allow the light to cool down before installing underwater. ATTENTION Fiberstars JAZZ and FX Series Wet-Niche Lighting Fixtures for Swimming pools are now ETL Classified for use with the following manufactures Wet-Niches for use in new Pool construction. PENTAIR, (American) model no. 79206700 (ABS), model no.
Page 3
Figure 1 Install fixture in a vertical pool or spa wall – not in floor. Failure to install the fixture properly could result in personal injury and/or property damage. Except when the fixture is installed in an area of the swimming pool that is not used for swimming and the lens is adequately guarded to keep any person from contacting it, the fixture shall be installed in or on the wall of the pool with the top of the lens not less then 18 in.
Page 4
3. Make connections in the junction box (see Figure 2). NOTE: The Auto Sync color wheel control wires must all be operated by one switch or relay for the synchronization to work. Figure 2 4. Insert cord into the niche and place the lamp housing in the niche. Be sure that the locator tab on the bottom of the lamp housing is in the notch at the bottom of the niche.
Page 5
NON-Dimming relay is required for color wheel control. All color wheel control wires for Auto Sync units are run to one common relay. Fiberstars RM-400 Wireless Remote Control (Maximum 2 units per RM-400) SPECIAL NOTE FOR X-10 CONTROL The lowest possible signal that can make a module respond properly is 150mV. Please refer to the X-10 installation manual.
Page 6
(Includes replacement gasket #7) J30-3000 Pilot Screw, with captive neoprene washer J30-4000 Face ring, Stainless Steel J30-5000 Compression Clamp J30-6000 Lens, Fiberstars, 8-3/8 in. dia., tempered J30-7000 Gasket, Lens SAVE THESE INSTRUCTIONS. Rev.E • 08/04/04 - 6 - P/N 75-15046-PM...
Need help?
Do you have a question about the JAZZ J400C and is the answer not in the manual?
Questions and answers