Steps For Starting Your Furnace - Payne PG9MAB Owner's Manual

WARNING
!
FIRE AND EXPLOSION HAZARD
Failure to follow this warning could result in personal injury,
death or property damage.
Should the gas supply fail to shut off or if overheating occurs,
turn off the manual gas valve to the furnace BEFORE turning
off the electrical supply and install lockout tag.
CHECK AIR FILTER: Before attempting to start your
S
furnace, be sure the furnace filter is clean and in place.
See "Performing Routine Maintenance" section in this
manual. Do not run the furnace without a filter in place.
Then proceed as follows:

STEPS FOR STARTING YOUR FURNACE

1. Set your room thermostat to the lowest temperature setting.
(See Fig. 6.)
Fig. 6 - - Lowest Temperature Setting
2. Close the external manual gas valve. (See Fig. 7.)
Fig. 7 - - Close Valve
3. Turn OFF electrical supply to the furnace. (See Fig. 8.)
Fig. 8 - - Turn Off Electrical Supply
4. Remove the main furnace door. (See Fig. 9.)
5. Turn the control switch on the gas control to the OFF position
and wait 5 minutes. (See Fig. 10.) Then smell for gas, includ-
ing near the floor. If you smell gas, STOP! Follow "B" on fur-
nace label. If you don't smell gas, go to next step.
A08175
Fig. 10 - - Control Switch to OFF
6. After waiting 5 minutes, turn control switch on the gas control
to the ON position. Turn the control switch to ON. (See Fig.
11.)
A06188
Fig. 11 - - Control Switch to ON
A92185
6
Fig. 9 - - Remove Furnace Door
ON
A08595
A05118
A08348