Yamaha Star XV250ZC Owner's Manual page 47

Tightening torque:
Oil filter element cover screw:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Make sure that the O-ring is properly
seated.
7. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
TIP
Check the washer for damage and re-
place it if necessary.
Tightening torque:
Engine oil drain bolt:
34 Nm (3.4 m·kgf, 24 ft·lbf)
8. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
PERIODIC MAINTENANCE AND ADJUSTMENT
Recommended engine oil:
See page 9-1.
Oil quantity:
With oil filter element replacement:
1.60 L (1.69 US qt, 1.41 Imp.qt)
Without oil filter element replace-
ment:
1.40 L (1.48 US qt, 1.23 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
G In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
7-12
9. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
10. Turn the engine off, and then
check the oil level and correct it if
necessary.
ECA11620
7