Set-Up - John Bunn Neb-u-Lite LX2 User Manual

set-UP

Note: Before initial operation, clean the nebulizer cup as-
sembly following the instructions given in MAINTENANCE/
Cleaning the Nebulizer Cup.
WARNINg: Ensure that the nebulizer compressor is un-
plugged during set-up.
1. Before each use, inspect the compressor and nebulizer
cup assembly for damage or wear; replace as needed.
2. Place the compressor on a table or other flat stable sur-
face (not on the floor), in an area that is clean and dust-
free. Be sure you can easily reach the controls when
seated.
3. Open the nebulizer medication cup: Twist the cap coun-
ter-clockwise until it stops, then lift cap off.
4. Pour the prescribed medication into the nebulizer medi-
cation cup. Do not fill with more than 5 ml per treat-
ment.
5. Install cap on cup. Turn clockwise to
tighten.
6. If using the mouthpiece for treatment,
proceed to step 7. If using an optional
mask, install the bottom part of the
mask directly onto the top of the neb-
ulizer medication cup cap as shown at
right. Proceed to step 9.
7. Insert mouthpiece into large end of
T adapter.
John Bunn Neb-u-Lite LX2 Nebulizer Compressor
cap
cup
install cap
on cup
mask
cap
install mask
on cap
T adapter
mouthpiece
assemble
mouthpiece
and T adapter
7