In Case Of Diffi Culty; Remote Control Unit - Kenwood CLX-70 Instruction Manual

In case of diffi culty

Resetting the Microcomputer
The microcomputer may malfunction (unit cannot be
operated, or shows an erroneous display) if the power
cord is unplugged while the power is ON, or due to
some other external factor. If this happens, execute
the following procedure to reset the microcomputer
and return the unit to its normal operating condition.
When the power is off (standby mode), press the
[AUX] and [4] buttons on the main unit until
"FACTORY RESET " is appears.
Unplug the AC cord and plug it back in if "RESET
FINISHED" appears.
• Please note that resetting the microcomputer will clear the
contents of the memory and return the unit to the state it
was in when it left the factory.
Check that following guide for problem resolution.
General
No sound.
\ Plug in AC cord securely.
\ Set the VOLUME control to proper sound level.
\ Make sure the source is set to the source you
want to operate.
\ Pull out the headphones plug from the
headphones jack.
The system does not operate by pressing any
buttons.
\ Unplug the AC cord and plug it back in.
This unit is turned OFF spontaneously.
\ A.P.S. is set to ON. Set it to OFF.
CD player operation
"NO DISC" is displayed.
\ Insert a disc correctly (label side facing
forward).
\ Clean the disc.
\ Use a new or readable disc.
\ Wait until the moisture condensation at the
lens has cleared.
Disc cannot be ejected.
\ Press and hold [0] button until "EJECT"
appears.
USB operation
"NO USB" is displayed.
\ Press
button again after press
\ Insert the USB device properly.
"NOT SUPPORT" is displayed.
\ Press
button again after press
22
CLX-70
Cannot play.
\ Check if the USB mass storage class-
iPod/iPhone operation
"NO iPod" is displayed.
\ Insert the iPod/iPhone properly.
Does not function properly.
\ Disconnect the iPod/iPhone and connect it
\ Check the software version of the iPod/iPhone.
SD operation
"NO SD" is displayed.
\ Press
\ Insert the SD card properly.
"NOT SUPPORT" is displayed.
\ Press
Cannot play.
\ Insert an SD card containing music fi les.
D.AUDIO operation
Kenwood digital audio player cannot be
controlled from the main unit or remote control
unit.
\ Connect using the connection cable
\ Check if a compatible model is connected.
Radio reception
Noise in radio.
\ Tune to a correct frequency.
\ Adjust the direction of the FM antenna.
\ Adjust the position and direction of the AM
\ Increase the distance between the system and

Remote control unit

Does not function properly.
\ Replace the batteries.
\ Remove the obstacles.
\ Move closer to the system when using the
button.
button.
compatible digital audio player is turned ON.
again.
If it is not the latest one, update it.
button again after press
button again after press
(separately available).
antenna.
TV or VCR.
remote control and make sure that you are
pointing at unit's remote sensor.
button.
button.