Aligning Table; Aligning Fence - Grizzly G0514XF Owner's Manual

Aligning Table

To align the table so the miter slot is parallel
to the bandsaw blade:
1.
2.
3.
4.
Make sure the straightedge does not go
across a tooth.
5.
Figure 47
6.
7.
Figure 47.

Aligning Fence

To align the fence parallel with the miter slot:
1.
2.
Note:
Figure 48.
3.
4.
Adjusting the fence parallel to the miter slot
does not guarantee straight cuts. The miter
slot may need to be adjusted parallel to the
side of the blade. Refer to the "Aligning
Table" instructions.
Figure 48
NOTICE